iTTUSB10 Owner's Manual V1.0 - Page 4
TONE ARM:
Items 12 – 16 are all parts of the tonearm. Refer to
the TONEARM SETUP section for additional details on these
controls.
12.
Counter Weight and Scale Ring:
The Counterweight is used
to balance the head shell and cartridge assembly so that the
proper amount of stylus pressure is applied to the record.
13.
Anti-Skate Adjustment:
This knob is used to compensate for
inward tracking forces. See TONEARM SETUP for more details.
14.
Arm Clip:
This specially designed arm clip secures the tone
arm while at rest or when not in use. The arm clip has been
designed to remain in the up position while unlocked.
NOTE:
When transporting the turntable, it is always
recommended that the headshell be removed and the arm clip
secured to prevent tonearm or turntable damage.
15.
Tone Arm Lock Nut:
This Aluminum nut is used to secure the
head shell and cartridge assembly to the tone arm tube. See
Cartridge Setup for more details.
16.
Cartridge and Headshell:
The cartridge is pre-mounted on a
standard headshell. The cartridge is user replaceable and
compatible with a variety of standard cartridges. Be sure to
remove the clear plastic cover before operating the turntable
and cartridge.
PLATTER SETUP
WARNING:
Incorrect Platter setup can lead to poor turntable
performance, platter instability or permanent motor damage.
1.
The rubber belt has been preinstalled onto the turntable
platter. However, please turn the platter over and make sure
that the belt is attached and is not twisted. If the belt has
come off during shipping, please place it around the inner
bottom ring of the turntable platter, as shown in #1 above.
2.
Install the Platter on the center spindle and press it down
firmly. Check to make sure that it rotates uniformly and does
not wobble excessively.
