6
Rear Panel
21
23
22
21.
Line Output:
Connect this output to a receiver, amplifier, or powered speakers.
Note:
Bronco LP’s volume control will not adjust the volume when the line output is in use.
22.
FM Antenna:
Adjust this wire for better FM radio reception. For AM reception, rotate the unit until the
best reception is found.
23.
Power Input:
The integrated power cable is connected here.
Operation
Headlights
Press and hold the
Power
button for 2 seconds to turn the headlights on and off.
Press and hold the
Source
button for 2 seconds to adjust the brightness.
Turntable Playback
Before use, please make sure to:
•
Remove the stylus protector. Reconnect the protective cap on the stylus when not in use.
•
Ensure the tonearm is free to move from the tonearm rest. Lock the tonearm in place again when not
in use.
1.
Set the Source to
Phono
and lift the turntable dust cover.
2.
Place a record on the turntable, over the central spindle on the slipmat.
3.
Set the
Speed
selector to 33, 45, or 78 rpm depending on the record.
4.
Lift the tonearm from the tonearm rest by using the
Raise Lever
and slowly move it over the record.
The turntable platter will start turning.
5.
Place the tonearm at the desired location of the record.
6.
Gently lower the tonearm onto the record to start playing.
7.
When Auto-Stop is On and the record is finished playing, the tonearm will automatically stop. Lift the
tonearm from the record and put it back on the arm clip rest.
8.
To manually stop the record, lift the tonearm from the record and return it to the arm clip.
Note:
Do not stop or turn the platter manually. Moving or jarring the turntable without securing the
tonearm clamp could result in damage to the tonearm.
Auto-stop Switch Operation
Certain types of records may have an auto-stop area outside the pre-set limit, so the turntable may stop
before the last track finishes. If this occurs, set the
Auto-stop
switch to the
Off
position. This allows the
record to play to the end, but it will not stop automatically. You must manually raise the tonearm and place
it back in the rest and then turn the power off to stop the turntable from spinning.
