Hydrosteel 6000 MANUAL
Ion Science Ltd
Page 10 of 39
Unrivalled Detection. www.ionscience.com
Using Hydrosteel 6000
Connecting the low temperature (LT-R) probe to the analyser
1
Attach one end of either the 70 cm or 200 cm gas sample tubes to the connector at the top of the
analyser as shown below. Tighten finger tight.
Note: we recommend that you use the shorter of the
two sample tubes. However, if you require the extension arms, you may find it necessary to use the
longer (200cm) sample tube.
2
Attach the other end of the sample tube to the LT-R probe. Tighten finger tight.
3
If required for extended use, attach one or both of the extension arms to collector assembly, as on the
next page.
