4
Ioline 300/350HF Quick Start Guide
Step 1: Install the Software
1.
Make sure that machine power is turned off by pressing the ‘0’
end of the power switch on the back of the right end cover.
6.
Restart the computer only if instructed.
7.
Connect the Ioline 301 Software key to a USB port on the PC
(
see
figure below
). Ioline recommends NOT using a USB hub
for the key. Windows will likely show messages about driver
installation when the key is inserted the first time.
The 301 software icon is placed on the desk-
top when installation is finished.
8.
The PDF
User Guide
and this
Quick Start Guide
and software
manuals are available under the
Manuals
tab on the product
support page.
Acrobat Reader
, is required to view manuals.
9. The optional
Ioline Control Center
software is available on the
Downloads
tab of the support page. This utility is normally
not required unless detailed machine setup is necessary or for
troubleshooting.
Install the drivers, then insert the USB key into the PC.
Older 300 and 350HF Systems
used a parallel key rather than
USB, as shown below:
Note
i
Make sure the power switch is OFF.
Power switch
set off to ‘0’
2.
Visit the online Ioline software setup page at
ioline.com/setup
.
3. Click on the picture of the
300/350HF
cutter then follow the
steps listed in the
Setup
tab.
4.
Follow the self-guided installation instructions for each instal-
lation program. If prompted, answer ‘
Yes
’ or
‘OK’
to all ques-
tions about installing drivers.
5.
The 301 installation program will place an icon on the desktop
for the 301 Software