IOGear GCE250, Installation Manual

Page: 23 / 44

23
Refer to the installation diagram on the following page as you perform these steps:
1. Plug the cables from the local console devices (keyboard, monitor, mouse), into their ports on the rear
panel of the Local Unit (GCE250L).
2. Plug the SPHD (yellow) end of the KVM cable supplied with this unit into the
KVM port on the front panel of the GCE250L.
3. Plug the connectors on the other end of the cable into the appropriate ports on the
computer (or Console section of the KVM switch - if you are using one). Each connector is marked
with an appropriate icon.
4. Plug one end of a Cat 5 or higher Ethernet cable into the GCE250L’s Remote I/O port. Plug the other
end of the cable into the GCE250R’s Remote I/O port.
Note: Ethernet cable is not supplied with this package. It requires a separate purchase. The cable can be
up to 150 m (500’) long.
Connecting