ON
1 2 3 4 5 6
MODE
DIP SWITCHES:
SWITCH 1 - Pairing mode when ON and
Normal operating mode when OFF.
SWITCH 2 through 6 - Not used.
PROG/TEST
PROGRAM/TEST BUTTON:
Used with MODE DIP SWITCH 1 to field-pair
transceivers.
Functions as a Test/Transmit button during
normal operation. When pressed, transceiver
sends a radio test packet and the RED
TRANSMIT LED will illuminate. Paired
transceiver will acknowledge the packet was
received with a radio test packet indicated by a
momentary GREEN RECEIVE LED.
FIELD-PAIRING TRANSCEIVERS:
1. Put MODE DIP SWITCH 1 in the ON
position for both transceivers.
2. Press the PROG/TEST button on either
transceiver. Observe that the STATUS/PROG
LED flashes.
3. Put MODE DIP SWITCH 1 in the OFF
position for both transceivers.
4. Press PROG/TEST on either transceiver and
observe that TRANSMIT and RECEIVE LEDs
operate normally.
Pairing procedure overwrites any previous
pairing. For example, if replacing only one
transceiver, simply follow the above
procedure with both the existing and
replacement transceiver.
COMPLIANCE:
The iO-WR-XR Wireless Transceiver has been
tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate
radio frequence energy, and if not installed and
used in accordance with the instructions, may
cause harmful interference to radio
communications. There is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by turning
the equipment off and on, the user is
encouraged to try to correct the interference by
one or more of the following measures.
- Reorient or relocate the receiving antenna.
- Increase the separation between the
equipment and receiver.
- Connect the equipment into an outlet or circuit
different from that to which the receiver is
connected.
SPECIFICATIONS:
Dimensions:
Power Input:
Channels:
Contact Rating:
Addresses:
Frequency:
Range:
Operating Temp:
Operating RH:
3.75” H x 5.25” W x 2” D
12 or 24 Volts AC or DC
2 Send, 2 Receive
10A per channel
Factory-paired
Multiple units can be used
in same location
902-928 MHz
1/2 mile
line of sight
-40°F to 185°F
0 to 95% (non-condensing)
OFF