INVT IPE300 Series, Opeartion Manual

Page: 184 / 383

IPE300 series engineering VFD Function parameter list
-173-
Function
code
Name Description Default Modify
P10.34
ACC/DEC
time of steps
0
–7 of simple
PLC
The description is as follows:
Function
code
Binary Step
ACC/D
EC
time 1
ACC/D
EC T2
ACC/D
EC T3
ACC/D
EC T4
P10.34
BIT1 BIT0 0 00 01 10 11
BIT3 BIT2 1 00 01 10 11
BIT5 BIT4 2 00 01 10 11
BIT7 BIT6 3 00 01 10 11
BIT9 BIT8 4 00 01 10 11
BIT11 BIT10 5 00 01 10 11
BIT13 BIT12 6 00 01 10 11
BIT15 BIT14 7 00 01 10 11
P10.35
BIT1 BIT0 8 00 01 10 11
BIT3 BIT2 9 00 01 10 11
BIT5 BIT4 10 00 01 10 11
BIT7 BIT6 11 00 01 10 11
BIT9 BIT8 12 00 01 10 11
BIT11 BIT10 13 00 01 10 11
BIT13 BIT12 14 00 01 10 11
BIT15 BIT14 15 00 01 10 11
Select corresponding acceleration/deceleration
time, and then convert 16-bit binary number into
hexadecimal number, finally, and then set
corresponding function codes.
ACC/DEC time 1 is set by P00.11 and P00.12 ;
ACC/DEC time 2 is set by P08.00 and P08.01 ;
ACC/DEC time 3 is set by P08.02 and P08.03 ;
ACC/DEC time 4 is set by P08.04 and P08.05 .
Setting range: 0x0000
–0xFFFF
0x0000
○
P10.35
ACC/DEC
time of steps
8
–15 of
simple PLC
0x0000
○
P10.36
PLC restart
mode
0: Restart from the first step, namely if the VFD
stops during running (caused by stop command,
fault or power down), it will run from the first step
after restart.
1: Continue running from the step frequency
when interruption occurred, namely if the VFD
stops during running (caused by stop command
0
◎