involight TRINITY200LED V.2, User Manual

Page: 25 / 61

24
1.3 Intended use.
The INVOLIGHT "TRINITY200LED" is a light unit with colored light effects. It was developed and designed for
professional use in the field of event technology - exclusively indoors. The device may only be used by persons with
sufficient physical, sensory and mental abilities as well as the appropriate knowledge and experience. Other persons
may only use the device if they are supervised or instructed by a person responsible for their safety.
The device is only approved for AC power, 100-240Volt and 50 / 60Hz power supply.
Light effect devices such as "TRINITY200LED" are sensitive and technically advanced devices that must be handled
with care. Therefore, avoid shocks and violence during assembly / disassembly and the use of the device.
Install "LEDMH200S PRO" only in places that are protected from dust, moisture and excessive heat. The approved
operating temperature must be in the range -5 ° to + 45 ° Celsius and the relative humidity must not exceed 50% (at +
45 °)! Direct sunlight should be avoided during use and during transport. In the interests of your own safety and those
of others, make sure that there are no cables around.
During thunderstorms, the device must be disconnected from the power supply!
Moving heads are generally to be secured with an approved safety rope when suspended!
"TRINITY200LED" is designed only for professional use, if you are familiar with the functions and are familiar with the
operation. Only allow other people to work with the device if you are sure they are familiar with the features as well. In
most cases, malfunctions are a consequence of a previous maloperation.
Damage resulting from failure to comply with the intended use and instructions given in this manual will void the
warranty and may result in consequences such as short-circuit, fire, electric shock, or dropping the device (s).
Unauthorized changes to the device are prohibited for security reasons.
The manufacturer is not liable for damage caused by improper installation and insufficient security!
Part 2: Installation.
Unpack the device and carefully check for damages before using it. Place the unit in a suitable place or hang it on a
suitable crossbar. For suspended installation, the device must be secured with an approved safety rope. In addition,
the mounting bracket must be screwed with the enclosed screws and tightened! Then connect the device to the mains
and, if necessary, connect a DMX cable and connect it to other devices or a DMX controller. More about DMX or
Master / Slave operation also in part 3 and 4.
During installation, provisions of the BGV C1 (formerly VBG 70) and DIN 15560 must be observed! Authorized
specialists may only carry out the installation!
IMPORTANT! Overhead mounting requires a lot of experience. This includes knowledge of the load bearing capacity,
the installation material used and the safety inspections of the material and the projector used, but the required
experience is not limited to this. If you do not have the appropriate qualification. Instead, commission a professional
installer. Incorrect installation may result in personal injury and / or damage to property.
NOTE!
Possible damage due to movement of the device.
Make sure there is enough room around the device for the movement of the head (pan,
tilt).