involight Trinity Plus, User Manual

Page: 20 / 28

- 16 -
9.Maintance and cleaning
It is absolutely essential that the fixture is kept clean and that dust,dirt and smoke fluid residues must not
buildup on or within the fixture. Otherwise, the fixtures light-output will be significantly reduced. Regular
cleaning will not only ensure the maximum light-output, but will also allow the fixture to function reliably
through out its life. A soft lint-free cloth moistened with any good glass cleaning fluid is recommended,
under no circum stances should alcohol or solvents be used!
The front objective lens will require weekly cleaning as smoke-fluid tends to building up residues,reduc-
ing the light-output very quickly.The cooling-fans should be cleaned monthly.
The gobos may be cleaned with a soft brush,The interior of the fixture should be cleaned at least annua-
lly usinga vacuum-cleaner or an air-jet.
There are no serviceable parts inside the device except for the lamp and the fuse.
Replacing the fuse: If the lamp burns out,the fine-wire fuse of the device might fuse,too.Only replace the
fuse by a fuse of same type and rating.Before replacing the fuse,unplug mains lead.
Maintenance and maintenance of the operation, please contact the manufacturer or distributor.
DANGER:Disconnect from the mains before starting any maintenance work.
Mode1 Mode2 Mode3 Name Function DMX Value
Blackout while gobo wheel moving step 110-119
Disabled blackout while gobo wheel moving 120-129
Lamp On,reset(total reset except pan/tilt reset) 130-139
Pan/Tilt reset 140-149
Colour system reset 150-159
Gobo wheels reset 160-169
Dimmer/Shutter 170-179
Zoom/focus/prism reset 180-189
Reserved 190-199
Total reset 200-209
Reserved 210-229
Lamp Off 230-239
Reserved 240-255
24 9 6 Effect Speed Speed of Rot. Gobo selection from max. to min. 0-255
Power/Special
functions
To activate following functions, stop in DMX value for at least 3
seconds:
23 6 4