16
output. Example: Set Dip Switch No. 1 to the "ON" position. The button 1 of the transmitter controls the snow
output. If you use 4 machines, they can be controlled with only one transmitter separately from each other.
4.4 Setting the DMX start address:
1. Press MENU until the display shows ADDR.
2. Confirm with ENTER.
3. Use the UP / DOWN buttons to set the value of 001 - 512.
Remember, the machine needs 1 DMX channel!
DMX is the abbreviation for digital multiplex and allows the digital control of several DMX devices via a common
control cable.
Connect the DMX input of the unit to the DMX output of a DMX controller or other DMX device. Connect the output
of the first DMX device to the input of the second and so on to form a series circuit.
DMX connectors:
A three-pin XLR socket serves as a DMX output, a three-pin XLR connector serves as a DMX input.
For installations with very long DMX cable paths or high electrical interference, such as in a discotheque, it is
recommended to use a DMX terminator. The DMX terminator is connected in an XLR connector as a 120
Ω resistor
between pins 2 and 3 which is plugged into the last output socket of the DMX line.
4.5 Activate the fluid sensor:
The fluid sensor checks whether there is still enough mist fluid in the tank and protects the pump from idling. You
can turn off this sensor as follows:
1. Press MENU until the display shows FLUD.
2. Confirm with ENTER.
3. Use the UP / DOWN buttons to adjust the value of ON or OFF.
4. Confirm with Enter again to exit the menu.
Please note that the pump can be destroyed if the fluid sensor is switched off. When the fluid sensor is
activated, and the machine no longer detects any fluid, it turns off the pump.
