17
Part 3: Functions:
Connect the "LED MH368ZW" to the mains. The device carries out the usual reset process. Wait for it to finish. The
touchscreen display is, so to speak, the heart of the "LED MH368ZW". All functions and modes can be set here. The
individual functions and modes are listed in a table below.
3.1 Touchscreen Display:
Menu structure:
DMX ADRESS
001-512
With the UP and DOWN buttons you can set the desired
DMX start address and confirm with ENTER.
RUN MODE
DMX
14 CH
In RUN MODE you can use the UP and DOWN buttons
to choose between DMX mode, AUTO mode and
SOUND mode. Confirm the selected mode with ENTER.
In AUTO mode, one of the eight programs must be
activated and confirmed with ENTER.
AUTO
AUTO1 bis
AUTO8
Sound
TEST MODE
PAN
000-255
Test PAN movement manually. Values can be set with
the UP and DOWN buttons.
TILT
000-255
Test the TILT movement manually. Values can be set
with the UP and DOWN buttons.
FOCUS
000-255
Test the FOCUS function manually. Values can be set
with the UP and DOWN buttons.
RED
000-255
Set the brightness of the red LEDs manually.
GREEN
000-255
Set the brightness of the green LEDs manually.
BLUE
000-255
Set the brightness of the blue LEDs manually.
WHITE
000-255
Set the brightness of the white LEDs manually.
LANGUAGE
English /Chinesisch
With the UP and DOWN buttons you can select the
desired menu language and confirm with ENTER.
SETUP
PAN REVERSE
ON/OFF
This function can be used to reverse the PAN movement.
TILT REVERSE
ON/OFF
This function can be used to reverse the TILT movement.
FADER DELAY
ON/OFF
With this function you activate the stepless dimming.
Stepless dimming reduces the slight flickering that can
occur with normal dimming.
SIGNAL LINK
ON/OFF
This function activates a buffer memory so that the last
setting is retained if the signal is lost.
CODE WHEEL
ON/OFF
With this function you activate the automatic correction of
the PAN / TILT position.
TEMPSWITCH
SET
ON/OFF
With this function you activate the warning if the
temperature of the LEDs exceeds a set value.
TEMPERATURE
SET
50° bis 120°
With this function you can protect the LEDs by lowering
the desired limit temperature for the LEDs. Setting range
is 50-120 ° C.
SCREEN SAVER
OFF/MODE1/M
ODE2
In this setting, the display switches off 60 seconds after
the last entry and switches on again as soon as you
make a setting. MODE1 - only the start address is
displayed. MODE2 - the display switches off completely.
DISPLAY
REVERSE
ON/OFF
With this function you can rotate the display by 180 °.
FACTORY SET
YES/NO
This function resets the device to the factory settings.
