7
InvisibleFence.com
MULTI-AREA AVOIDANCE
Your Indoor Micro Shields® Transmitter and the Computer Collar® unit are preset to operate on
Channel A (CH.A). For homes with two or more pets, this setting is usually sufficient as long as
all pets are required to avoid the same protected areas like keeping all pets away from the trash,
off the counter tops off the sofa, etc. In some multi-pet homes, it may be desired to allow one pet
access to an area while denying access to another pet.
• When set to Channel A (CH.A), the Indoor Micro Shields® transmitter denies access to pets wearing a
Computer Collar unit programmed to Channel A. (Channel A is the default setting for the Computer
Collar unit.)
• When set to Channel B (CH.B), the Indoor Micro Shields transmitter denies access to pets wearing a
Computer Collar unit programmed to Channel B.
• When set to Channel A-B (CH. A and CH.B), the Indoor Micro Shields transmitter denies access to all
pets wearing a Computer Collar unit.
Programming the Computer Collar® Unit
1. Prior to programming ensure all Computer Collar
units are removed from pets and are at least 3 feet
from the Indoor Micro Shields transmitter.
2. Follow procedure above, Changing the Channel
Setting on the Indoor Micro Shields Transmitter, to
select Channel A or Channel B for programing into
the Computer Collar unit. Note: The Indoor Micro
Shields transmitter will not enter into programming
mode if this switch is set to A+B. Turn the unit back
over and set it down on a flat surface.
3. Press and hold the PROGRAM button while lowering the Computer Collar unit from directly above
the Indoor Micro Shields transmitter.
4. Stop lowering when the Computer Collar unit begins to flicker yellow and release the PROGRAM
button on the transmitter when the Computer Collar unit begins to flash green.
5. The Computer Collar unit is now programmed to the desired channel.
6. Verify operation by turning ON the Indoor Micro Shields transmitter and listening for the Computer
Collar unit activation.
Note: Make sure any Computer Collar units you do not wish to program are more than 3 feet from the
Indoor Micro Shields transmitter or have the Power Cap® Battery removed. Do not perform this procedure
while the Computer Collar Unit is on a pet.
