background image

Features and Functions

The ICT 700 transmitter is microprocessor con-

trolled and designed to work with an Invisible Fence

®

Computer Collar

®

to contain your pet within the areas

you select, or to teach your pet to avoid specific areas
such as flower beds, gardens, or a pool.

The ICT 700 pet containment system is designed

for up to 3,000 feet(915m) of loop wire and up to 150
feet(45.75m) of twisted pair wire. There is no hazard
in touching or exposing the wire because the wire car-
ries only low voltage electricity.  

To operate the ICT 700 plug transformer into the

transmitter’s 12vAC power jack, and then plug the
transformer into a grounded 110vAC outlet. 

Users

with other electric sources should ask their Invisible
Fence professional for an appropriate adapter

.

The ICT 700 transmitter has a green LED to indi-

cate that the power is on, and there is no break in the
signal field wire. During normal operation the green
LED is ON for one second, then OFF for four seconds. 

The ICT 700 has both an audible and visual

BreakAlert

®

wire break warning. If there is a break in

the signal field wire, the green LED will remain on
and the BreakAlert will sound an alarm until the break
is repaired or the transmitter is turned OFF; discon-
nected from the transformer. The ICT 700 also has a

coarse and a fine signal
field adjustment knob, and
a switch that changes the
channel 

of 

operat i o n

between 7K, the DOWN
position, and 10K, the UP
position.

Removing the 
ICT 700 Cover

To take the cover off

the  tra n s m i t t e r, hold  the
base of the transmitter in
one hand and, using the
thumb and index finger of
your  other  hand, ge n t ly
compress the top and bot-
tom of the cover plate and
remove it.

To put the cover back

on, align the two tabs on
the top of the cover plate

with the two slots, on the top of the base, and slide the
tabs into the slots. Lock the cover in place by sliding
the bottom tab of the cover plate into the bottom slot
in the base.

The Signal Fi e l d

I nv i s i ble Fence tra n s m i t t e rs produce a coded, low

power radio signal which travels from the transmitter,
along the signal field wire and back to the transmitter
to produce a Invisible Barrier

®

wall. This signal is

what activates your pet’s Computer Collar receiver.

The ICT 700 system functions only when the sig-

ICT 700 Installation

3

Summary of Contents for ICT 700













Reviews: