Technical parameters
Inputs
4 x IF inputs from Quattro LNB
Outputs
4 x Loopthrough satellite IF outputs
1 x Unicable output to connect up to 4 receiver tuners
Frequency range
Satellite: 950-2150MHz
Loopthrough loss
Satellite: max -3dB
Gain
Satellite: 10dB (min)
Isolation
Satellite-Satellite outputs: min 30dB
Control protocol
DiSEqC™ commands extension according to CENELEC
prEN50494
Power consumption
20VDC, 225mA
Dimensions (W x H x D mm)
W=88 H=120 D=35 mm
Temperature range
-20C - +60C
AC/DC adaptor
Input voltage: 100-240VAC, 50/60Hz
Output voltage: 19VDC
Output current: 940mA
Short circuit protection: Yes
Power Inserter
Input voltage: 20VDC
Output power: 15VDC, 600mA
Troubleshooting
Make sure the satellite antenna and LNB are properly fixed, connected and adjusted and that the
satellite receivers are installed, connected and switched on according to available instructions.
Ensure there is no short circuit on the product inputs. This will prevent power to the LNB. If this is the
case, disconnect the product from the main power, and then find and remove the short circuit on the
product inputs. Then re-connect the multiswitch to the main power.
Frequent defects are in connector joints i.e. if the central conductor is too short and fails to make
contact in the connector. Also the shielding braid should make proper contact with the connector
coat. Sometimes a reset to the multiswitch microprocessor is sufficient to remove a fault: simply
disconnect the multiswitch from main power for 30 seconds and then reconnect again.
If you are unable to remove the fault yourself, please contact your distributor.
Disposal
Following relevant EU directives, this device shall not be disposed of together with municipal waste.
Use local waste collection and recycling systems to dispose wore out products.
*
DiSEqC™ is a registered trademark of Eutelsat
*
For purpose of brevity, some product descriptions in this sheet remain at platform level and may not be
referred to as detailed datasheets of the products. Inverto Digital Labs reserves the right to amend, omit or
add products, product-lines, and/ or features without notice.
Installation manual
Unicable
™
Multiswitch
IDLP-USW1O2-CUO1O-4PP
4
V161013
V/L
V/H
H/L
H/H
Satellite - Input
H/H
H/L
V/H
V/L
Satellite - loop-through output
TM
Unicable cascadable switch 4 User Bands
IDLP-USW1O2-CUO1O-4PP
User Bands :
0 : 1210MHz
1 : 1420MHz
2 : 1680MHz
3 : 2040MHz
Satellite inputs: IF 950-2150MHz
Satellite Loop-Through loss: -3dB
Unicable Out
