3
Thank you for purchasing Inverto’s advanced Unicable II multiswitch and we are certain it will
meet your expectations. Before installing and operating the product, please read the following
instructions and recommendations. We suggest that you keep this manual for future use.
Warranty
This Unicable II multiswitch is designed for the distribution of satellite and terrestrial television
and radio signals in home installations. The warranty does not apply for products used for oth-
er purposes than those specified herein. The user/installer shall be responsible for any dam-
age incurred as a result of not using the product according to the instructions in this manual.
Installation location
The product shall be installed on a wall or other hard inflammable surface.
The product shall be in no case held only with the connected cables.
Place the product in a dry environment where it is not exposed to rain or running water.
Do not install the product close to heat sources or in places exposed to direct sunlight.
Product installation
The following diagram may assist you when drilling the holes:
To connect the product inputs and outputs use high-quality co-
axial cables designed for satellite reception and F-connectors.
Use a highly shielded coaxial cables with minimum shielding
of 90dB. If you use wall sockets to loopthrough the Unicable II
output, make sure the wall sockets were designed for satellite
reception compatible with Unicable technology and allows bidi-
rectional signal propagation.
The multiswitch can be powered over any of its output ports by
any of the connected STBs if it is able to supply the necessary
power to the switch and the Quattro LNB connected to it. If none
of the connected STBs can supply sufficient power, the mul-
tiswitch shall be powered by the supplied AC/DC adapter and
Power Inserter over its Unicable II port.
Product default configuration
The factory default configuration of the output ports is as marked on the device’s label. By
default, the Unicable II port operates in dynamic mode (compatible with EN50494/EN50607)
and supports up to 32 User Bands. The list of the User Bands’ parameters appears on the
next page.
The default functionality of the output ports can be changed. The Legacy (Universal) port can
be configured to function either as a Universal port (default) or as a Unicable II port. A Unica-
ble II port can be configured to operate in dynamic or static mode.
Note: For optimal performances, the loop through outputs that are not used shall be terminat-
ed with 75ohm DC-decoupled terminating resistors.
Note: The default configuration of the product, can be updated using Inverto’s Programmer
device (not supplied with the product and sold as a separate accessory)and PC Windows
software that can be downloaded from www.inverto.tv.
Learn more about the Dynamic and Static operating modes on www.inverto.tv.
100
98
20.80
Unicable II
Programmable Cascadable switch
with 32 User Bands with Terrestrial input & 1 Legacy port
IDLU-UST110-CUO1O-32P
Item: 5151
Satellite inputs: IF 950 - 2150MHz
Terrestrial input: 47 - 862MHz
Satellite Loop-Through loss: 3dB
Terrestrial Loop-Through loss: 3dB
Leg
acy Out
(+T
er
r)
Satellite - Loop-through output
Terrestrial loop
through output
Terrestrial input
M a d e i n C h i n a
D e s i g n e d i n L U
P
ower in (+T
er
r)
Satellite - Input
V/L
V/H
H/L
H/H
V/L
V/H
H/L
H/H
For default UB frequencies:
www.inverto.tv/dCSS-UB
Summary of Contents for Unicable II 5151
Page 2: ...2...
