Inverto IDLB-ALCF60-KUANO-LPS, Installation Manual

Page: 6 / 48

2
Safety
The Inverto parabolic antennas are intended solely for the reception of satellite signals and for use only as a do-
mestic antenna. The antenna should have no more than 6m free mast length and a fixed-end moment up to 1650
Nm. It is unsuitable for mounting on structures that are subject to vibration. Make absolutely sure that the values
for the maximum load listed in the Technical Data (on page 10) are complied with, if this load is exceeded the
mechanical integrity of the dish may be compromised.
Prior installation follow local safety regulations
Read the installation guide before mounting the satellite dish
Before you install, connect or use the parabolic antenna, make sure that you have read this installation guide and
comply with all of its requirements. Not doing so may result in:
• Risk of injury
• Malfunctions and loss of performance.
• Permanent damages to the antenna.
In such an event the manufacturer will not accept liability for malfunctions and damage arising!
BASIC SAFETY PRECAUTIONS
• Do not install the antenna in the vicinity of overhead power cables and maintain a clearance of at least
1m from all other electrical devices in all directions! If you or metal parts of the antenna touch any
electrical device there is a serious risk of a fatal electric shock!
• Never work on antenna systems during a thunderstorm or when a thunderstorm is approaching. There
is a risk of a fatal electric shock!
• Never install antennas on buildings with easily flammable roof coverings such as straw, reeds or similar
materials! This may cause a risk of fire due to atmospheric over-voltages (static charges) or lightning
discharges (e.g. during thunderstorms).
• It is always recommended to have the installation work performed by a professional. This installation
guide assumes good craftsmanship capabilities and knowledge of the behavior of materials under the
effects of wind.
• The person doing the work must wear proper non-slip footwear, must not be subject to dizziness, must
be able to move around safely on the roof and have a secure standing and attachment position (if
necessary, wear a safety harness when on the roof).
• Make sure that the roof is able to bear your weight. Never walk on fragile or unstable surfaces! In case
of doubt, contact a qualified specialist installer or specialist roofing contractor to find an appropriate
installation location.
• Use safety harness that is in good condition. in case you have to work on high places.
• Ladders or other means of climbing used for installation must be in faultless condition (dry, clean and
non-slip).
• If there is a risk that passers-by may be injured by items falling from above during installation, you must
close off the risk area using barriers! Make sure that no-one is underneath the installation location.
• Avoid risk of death or injury due to falling from the roof, falling through the roof and falling parts, plus
the possibility of damage to the roof.
• The respective national safety regulations and current standards should be complied with.
• Any other use or failure to comply with these instructions will result in voiding of warranty coverage.