BALNAFETTACH HOUSE, PH26 3LW (01479) 872 518 [email protected]
6.
Re-fill the fluid tank and as with the first-time initial setup do allow the liquid to
absorb for at least 30 minutes before using the MF3.
NOTE:
If during operation the MF3
does not produce any smoke but you hear a ‘bubbling’
sound
–
STOP immediately as there is excessive fog liquid inside the heating coil.
Try “flicking” the MF
3 away from you to expel the liquid from the barrel. DO THIS OVER
A SINK!
. Then try gently tapping the MF3 barrel on a flat surface to expel the liquid.
If this does not work
–
you will need to change the heating coil.
Troubleshooting
No smoke is emitted even though the fan spins and the top LED is blue when you press the
main button
Ensure the heating coil is fully tightened. If the problem persists, carefully insert a fine
screwdriver or other rod-like object into the barrel of the MicroFogger (the hole from which
smoke is emitted) while the unit Rocker Switch is turned off.
Briefly apply light pressure to the screwdriver, this will ensure that proper electrical contact
is restored. Remove the screwdriver and try again.
Should this error persist, replace the coil with a new one.
Fluid Tank Leaking
Ensure both the heating coil and the tank are fully screwed home (finger tight). If problem
persists
–
ensure all white gaskets on the heating coil and the tank are properly and securely
in place (and undamaged).
MicroFogger W
on’t
Turn ON
Plug it in to charge (
with the Rocker/Toggle Switch
‘ON’
) and wait at least 4 hours until the
MicroFogger recharges.
MicroFogger W
on’t
Charge
If the MF3 is in a critically low battery state, the flashing LED may not come on for the first
30 minutes of charging. If LED lights and codes do not display after this time, please try
using another charger and micro-USB cable to diagnose whether it is an issue with the MF3
or not.
