2. Push the appliance in the correct position. Refer to the dimensions in the figure.
Caution:
Be careful not to crush or bend the hoses during positioning of the appliance.
Note:
The minimum height A (820 mm) is suitable for appliances that do not have a felt layer on top.
The minimum height B1 (830 mm) is suitable for appliances that have a felt layer on top and have a
second basket.
The minimum height B2 (835 mm) is suitable for appliances that have a felt layer on top and have a
cutlery drawer.
CONNECTING THE APPLIANCE
1. Connect the drain hose directly to the drain hole or to the siphon. The connection must have a
minimum height of 50 cm and a maximum height of 110 cm. Refer to the figure.
2. Do not let the drain hose hang lower than the appliance. Refer to the figure.
6
Operation
PREPARING FOR OPERATION
1. Do a check if the electricity and the water supply connections of the appliance match the values indicated in the
installation instructions.
2. Remove all packaging material inside the appliance.
3. Fill the salt reservoir. Refer to section
.
4. Fill the rinse aid reservoir. Refer to section
'Filling the rinse aid reservoir'
FILLING THE SALT RESERVOIR
For a good result the appliance needs soft (less calcareous) water. Salt is used to soften the water and it prevents
white lime residues on your dishes and the interior of the appliance.
Caution:
Only use salt that is suitable for a dishwasher. Do not use table salt.
Note:
Fill the salt reservoir when the salt indicator on the control panel is on.
1. Remove the lower basket.
2. Turn the cap (A) of the salt reservoir counter-clockwise to remove it.
3. Fill the salt reservoir with water.
Note:
You only have to fill the salt reservoir with water before first use of the appliance.
4. Put a funnel in the opening of the salt reservoir.
(Figure 5)
(Figure 6)
(Figure 7)
(Figure 8)
(Figure 9)
English
•
45
