tips
5
• High ambient temperatures have a negative effect on energy use. Keep the appliance in a position away from direct sunlight or
other sources of heat.
• Keep ventilation openings free. Clogged openings lead to higher use of energy.
• Try not to open the door too often, especially when the weather is wet and hot. Once you open the door, mind to close it as soon as
possible.
• The space between the shelves and the rear wall of the refrigerator compartment must be unobstructed to allow the cool air to
circulate. Therefore don’t place any food items against the back.
• Turn the thermostat to a lower setting when the circumstances allow it.
• Before storing fresh cooked food, make sure the food has cooled at least to room temperature.
• Ice and frost layer increase energy consumption, so clean the appliance as soon as the layer is 3 to 5 mm thick.
• If the gasket is damaged or if it turns out that the sealing is poor, the energy consumption is substantially higher. To restore
efficiency, replace the gasket.
• Always consider the instructions, otherwise the energyconsumption is substantially higher.
cleaning & maintenance
6
Before cleaning the appliance set the thermostat to OFF and always unplug the appliance.
Clean the interior of the appliance. Use warm water and a neutral detergent to prevent any bad smells occurring. After cleaning, rinse
the interior with clean water and rub dry. Leave the appliance to dry for 1 to 2 hours. Simply remove the shelves, drawer and door
compartments to clean them by hand. Do not clean the interior accessories in the dishwasher.
Clean the outside of the appliance and the gasket with a soft moist cloth.
REPLACING THE LED LIGHTING
This appliance is equipped with a LED light bulb. It can be used for a long time. In case, the LED bulb is blown, it must be replaced by a
qualified person to avoid any hazard. Contact the Inventum service department.
troubleshooting
7
Problem
Cause
Solution
Appliance is not functioning;
light does not work
Appliance is not plugged in
Plug the appliance in the socket
Temperature inside the
larder is too high or too low
Thermostat has been set
incorrectly
Set the thermostat correctly
Air circulation vents are blocked Clean the ventilation openings
Appliance is excessively noisy
Has the appliance been
installed correctly?
Check the installation
Are the pipes at the back
touching or vibrating?
Check it and move the appliance forwards
Note:
gurgling and hissing noises due to expansion in the refrigerant circuit are normal.
English
•
21