inventum IVW6040A, User Manual

Page: 52 / 108

Problem Possible cause Possible solution
The level of rinse aid consumption is
set too low.
Adjust the level of rinse aid
consumption. Refer to section
'Setting the level of rinse aid
consumption'
.
The appliance is unloaded too
quickly after the program is finished.
Wait a few minutes after the program
is finished before you unload the
appliance.
There are rust stains on the dishes. The stainless steel quality of the
dishes is insufficient.
Make sure that you only clean
dishwasher-safe dishes in the
appliance.
The level of salt consumption is set
too high.
Adjust the level of salt consumption.
Refer to section
'Setting the level of
salt consumption' .
The cap of the salt reservoir is not
closed correctly.
Make sure that the cap of the salt
reservoir is closed firmly.
Any spilled salt during filling of the
salt reservoir was not cleaned
immediately.
Make sure that you clean any spilled
salt immediately and run a full
program to prevent corrosion.
The water supply is polluted. Do a check on the water supply.
FAULT CODES
The fault codes are shown on the display of the control panel.
Fault code Possible cause Possible solution
F5 There is insufficient water supply.
• Make sure that the water tap is fully open and that
the water supply is not blocked.
• Close the water tap, remove the water inlet hose and
do a check if the hose is clogged.
• Start the appliance again.
• Contact the Inventum-servicedienst if the fault code
keeps re-occuring.
F3 The water supply does not stop.
• Close the water tap.
• Contact the Inventum-servicedienst.
F2 The waste water in the appliance cannot
be discharged.
• Do a check if the drain hose is clogged.
• Do a check if the filters are clogged.
• Switch the appliance off and reset the program. Refer
to section
'Resetting the program'
.
• Contact the Inventum-servicedienst if the fault code
keeps re-occuring.
F8 The heater has an error. Contact the Inventum-servicedienst.
F1 The safety for water overflow is
activated.
Contact the Inventum-servicedienst.
FE There is an electronic error. Contact the Inventum-servicedienst.
F7 The temperature of the appliance is too
high.
Contact the Inventum-servicedienst.
52 • English