RINSE AID CONSUMPTION SETTINGS
Level
Number of rinse aid doses that is dispensed
Display indicator
1
Rinse aid not dispensed
r1
2
1 dose
r2
3
2 doses
r3
4
3 doses
r4
5
4 doses
r5
8
Troubleshooting
GENERAL TROUBLESHOOTING PROCEDURE
1. Try to find a solution for the problem with the help of the troubleshooting table and the fault codes.
2. If you cannot find a solution for the problem, reset the appliance. Refer to section
.
3. If the fault code keeps re-occuring, contact the Inventum-servicedienst.
TROUBLESHOOTING TABLE
Problem
Possible cause
Possible solution
The program does not start.
The mains plug is not connected.
Connect the mains plug.
There is a problem with the fuse.
Do a check on the fuse box.
There is no water supply.
Open the water tap.
The door of the appliance is open.
Close the door.
The appliance is switched off.
Start the appliance. Refer to section
.
The water inlet hose and filters are
clogged.
Make sure that the water inlet hose
and the filters are not clogged.
The detergent reservoir contains
detergent residues.
The detergent reservoir is filled while
the reservoir was still damp.
Make sure that you fill the detergent
reservoir when it is dry.
The appliance contains water when
the program is finished.
The drain hose is clogged or twisted. • Make sure that the drain hose is
not clogged.
• Make sure that the drain hose is
not twisted.
The filters are clogged.
Clean the filters. Refer to section
The program has not finished.
Wait until the program is finished.
A buzzer sounds five times and the
ready indicator is on when a program
is finished.
The appliance stops during a
program.
There is a power failure.
Make sure that there is power.
There is a water inlet failure.
Make sure that there is water inlet
supply.
The program is paused.
Start the program.
The appliance makes unusual
sounds during a program.
The appliance is not loaded
correctly.
Make sure that you load the
appliance correctly. Refer to section
English
•
47
