inventum IOP6035RT, User Manual

Page: 35 / 92

5. Fasten the appliance to the kitchen furniture. Use the screws (D).
6. Install the covers (C).
7. Close the door.
8. Connect the appliance. Refer to section 'Connecting the appliance' .
CONNECTING THE APPLIANCE
1. Make sure that the voltage in your home corresponds with the voltage of the appliance.
2. Make sure that the electrical system in your home is supplied with a 16 Amp fuse.
3. Use the supplied mains cable to connect the appliance to the mains socket.
After connecting, the clock shows '00:00' and you will hear a sound signal.
REPLACING THE MAINS CABLE
If necessary, you can replace the supplied mains cable with a longer or different mains cable.
Warning:
Replacing the mains cable must be carried out by a qualified person.
Note:
Make sure that the new mains cable has a minimum core cross section of 1.5 mm2 and a length of 1 m.
If you use a mains cable that is too short, you cannot connect the appliance and position it in the kitchen
furniture before connecting the appliance to the mains socket.
1. Find the terminal box at the rear of the appliance.
2. Carefully push the pins (B) to open the cover (A). Use a screwdriver.
3. Remove the screws (C).
4. Place the new mains cable (D) in the terminal box.
5. Connect the wires according to the wiring diagram.
6. Install the screws.
7. Close the cover.
5 Operation
PREPARING FOR OPERATION
1. Remove the accessories from the appliance.
2. Clean the appliance and the accessories. Use warm water and a mild cleaning agent.
3. Rinse the appliance and the accessories thoroughly with water.
4. Dry the appliance and the accessories.
5. Use the oven for 60 minutes with a temperature of 250°C to remove any production residues, such as oil and to
prevent bad smells. Refer to section 'Using the oven function' .
Warning:
Make sure that the room is properly ventilated.
6. Let the appliance cool down.
7. Clean the appliance again. Use warm water and a mild cleaning agent.
8. Rinse the appliance thoroughly with water.
9. Dry the appliance.
10. Install the guide racks. Refer to section
'Installing the guide racks'
.
INSTALLING THE GUIDE RACKS
1. Identify the guide racks for the left side (A) and the right side (B).
2. Push the guide rack (C) in the opening at the rear of the appliance.
3. Push the guide rack in the opening at the front of the appliance.
(Figure 5)
(Figure 6)
(Figure 7)
English • 35