THE FITTING OF THE APPLIANCE
• Check that the cabinet and the cut-out meet the dimension and ventilation requirements.
• Remove the chips from the cutting job in the opening of the worktop and treat the saw ends of wooden or synthetic
worktops with sealing varnish if necessary, to prevent moisture causing the worktop to swell.
• Lay the hob upside down on the worktop.
• Fit the connecting cable to the appliance in compliance with requirements.
• Remove the protective layer from the sealing tape and apply the tape on the edge of the glass plate. Make sure to apply
the tape to the glass and not on the metal part. Do not stick the tape around the corners, but cut 4 separate pieces to
seal the corners well.
Attention:
any damage that occurs when not applying the tape has concequences for the warranty.
• Fit the supllied mounting brackets on the appliance.
• Turn the hob over and lay it in the recess.
• Connect the appliance to the mains. The appliance is ready for use.
• Check that it works properly. If the appliance has been wrongly connected either a bleep will sound or an error code will
appear on the displays.
REMOVING THE HOB
Disconnect the hob from the mains. Remove the hob by pushing it upwards from the bottom.
Attention!
Beware of damage
to the appliance! Do not try to remove it from the top.
problems & solutions
8
If there is an error, an error code will be shown at the displays.
Error code
Cause
Solution
E1
Cooling fan is disabled.
Contact the service department of Inventum.
E3
Supply voltage is too high.
Have the installation checked by a qualified
electricien.
E4
Supply frequency is different from
the rated values (50Hz).
Have the installation checked by a qualified
electricien.
E5
The hob is overheated.
Switch the appliance off and let the cooking zones
cool down.
E6
Control defect.
Contact the service department of Inventum.
E7
Coil temperature sensor is defect.
Contact the service department of Inventum.
E8
Cooler temperature sensor is
defect.
Contact the service department of Inventum.
E9
Calibration error.
Contact the service department of Inventum.
32
•
English
Summary of Contents for IKI6031
Page 2: ...2...
Page 19: ...Nederlands 19...
