Questions? Contact INVENT3D via on-line ticketing system at
http://support.inventorcloud.net/
and click INVENT3D Printer for updates and documents
9/9/16
8.
Attach the side channel to the printer frame using only the bottom two holes. Make sure the wiring
is all contained within the channel as it was when it was first removed. Do not overtighten black
thumbscrews.
9.
Attach the filament guide to the frame using the top two holes on the side channel and the
remaining black thumbscrews. Place the free end of the filament tube into the top of the extruder
drive as shown below.
10.
Connect the power supply by attaching it to the power plug on the back of the printer. Once that is
complete, follow the procedure in the instructions on board leveling and z-axis calibration.
Appendix A: Side Box Contents
1.
INVENT3D Welcome Guide
2.
Printer Operating Instructions and Troubleshooting Guide
3.
USB Cable (if printer is used for direct drive off of a printer)
4.
Filament Guide with Filament Tube attached
5.
2 Black Thumbscrews
6.
2 White Thumbscrews
7.
Spool Holder
8.
Power Supply
9.
Scraper
10.
Test part (Printer operation validated at INVENT3D production facility. Test file on SD card.)
Filament Tube
Filament Guide
Top Black
Thumbscrews
Bottom Black
Thumbscrews
