Troubleshooting
Suspected malfunctions are often due to causes that the user can fix themselves.
Therefore check the product using this section. In most cases the problem can be
solved quickly.
Problem
Possible cause
Solution
1. Product does
not start
1. Not connected to power
supply
2. Power cord or plug is
defective
3. Other electrical defect to
the product
4. Lock-off button not
pressed
1. Connect to power supply
2. Check by a specialist
electrician.
3. Check by a specialist
electrician
4. Press the lock-off button first,
then the start lever
2. Product does
not reach full
power
1. Extension cord not
suitable for operation with
this product
2. Power source (e.g.
generator) has too low a
voltage
3. Air vents are blocked
1. Use a suitable extension cord
2. Connect to another power
source
3. Clean the air vents
3. Unsatisfactory
result
1. Cutting device is worn
2. Cutting material exceeds
capacity
3. Cutting height is incorrect
4. Wheels on different height
level
1. Replace with a new one
2. Only cut materials according
to capacity of the product
3. Adjust cutting height
4. Adjust the wheels on the
same height level
WARNING!
Only perform the steps described within these
instructions! All further inspection, maintenance and repair work
must be performed by an authorised service centre or a similarly
qualified specialist if you cannot solve the problem yourself!
72
Summary of Contents for INV E1334 P
