9
inVENTer Connect controller platform | Installation instructions
SYSTEM OVERVIEW
1.1 Connect inner cover
Construction
The Connect inner cover (in the following text "inner cover") is a network inner cover (radio or
RS485 data cable) and replaces the standard inner covers of the iV-Smart+, iV14-Zero, iV-Light
and iV-Compact ventilation devices to facilitate integration into the inVENTer Connect network. In
addition to the radio interface, the inner covers have local control electronics, a power supply unit
and an automatic closing flap.
It controls the speed and direction of each decentralised inVENTer ventilation device with heat
recovery connected to it.
Paired (by radio or by cable) with the controller, it is controlled by the latter.
The inner cover is white (RAL 9010) and features a flat, unobtrusive and elegant design. It is
available as a flush-mounted (UP) or surface-mounted (AP) inner cover.
The separate housing (240 x 240 x 38 mm) is available in two diameters, depending on the
ventilation device:
• Diameter 160 for R-D160 wall sleeve
• Diameter 200 for R-D200 wall sleeve
Figure 2: Connect inner cover, construction
1
Automatic closing flap (AVK)
2 Filter
Standard: Dust filter ISO Coarse 45 %
Pollen filter ISO Coarse 75%
or activated carbon filter
3 Electronics cover
4 Surface-mounted frame (only for
surface-mounted version)
5 Holding plate
6 Housing
2
1
6
5
4
3
Indoor use
