ø = 6 mm
40 mm
Positions of the Flair XL inner cover adapter
Fan BUS top left
Fan BUS top right
Fan BUS bottom right
Fan BUS bottom left
(position ex works)
29
INSTALLATION AND ASSEMBLY
iV-Office ventilation device
•
Installation and operating instructions
►
Remove the thread locks from the fixing elements
of the wall sleeve.
►
Place the base plate on the interior wall with the
inner cover adapter centrally to the wall sleeve.
►
Align the base plate with the inner cover adapter
using a spirit level.
►
Mark the four corner drill holes.
►
Drill the four holes with Ø 6 mm, min. 40 mm deep.
4.7
Installing the inner cover base plate
TIP:
The adapter for the Flair XL inner
cover is pre-assembled at the factory so that
the cable entry is located at the bottom left
when it is being attached.
If the cable is long enough, it can optionally
be laid between the adapter and the sound
insulation lining to the cable entry. To ensure
that the fan can be connected correctly even
if the cable routing is changed (e.g. cable
comes from the top right), the orientation
of the adapter can be changed. If necessary,
change this by removing the base plate from
the adapter. The cable entry in the adapter
is located near the connection cable
for the controller.
Spirit level, pen, hex key
Requirements:
The thermal accumulator insert has been installed.
