inVENTer 1001-0200, Installation Instructions Manual

Page: 5 / 40

5
USER AND SAFETY INSTRUCTIONS
5 iV-Light ventilation unit | Installation instructions
1.2 Safety instructions
The installation instructions are part of your iV-Light ventilation unit and must be available at
all times (see www.inventer.de/downloads). When handing the system to a third party, the
information regarding access to the installation instructions must be handed over also.
Before performing any work on the equipment/system, read the installation instructions carefully
and observe all notices that refer to the installation process in this section.
Also note the safety instructions that precede the described handling instructions.
Non-observance of safety instructions could result in injury and/or property damage.
These installation instructions only cover the standard variant (referred to as the "Standard vari-
ant" in the following text) of the iV-Light ventilation unit. Information on the variants can be found
in the separate installation instructions for the respective components.
Intended use
The ventilation unit is designed to ventilate dwellings and similar residential spaces. It is controlled
via an inVENTer system control unit (hereinafter referred to as the "controller").
General information
• Always observe the relevant standards, regulations and guidelines when installing the
equipment / system. In particular also applicable building regulations, fire safety regulations
and accident prevention regulations of the employers' liability insurance association.
• Use the equipment/system exclusively for the applications that are described in this
documentation and only in conjunction with components that are recommended, authorised
and described by inVENTer GmbH in this documentation.
Changes or modifications to the equipment/system are not permitted.
• Your ventilation system is exclusively designed for use in ambient temperatures between
-20 and 50°C.
• Trouble-free and safe operation of the equipment / system depends on proper transportation,
proper storage and installation, as well as careful operation and cleaning / care.
Installation and assembly
• CAUTION: The system may only be installed by qualified personnel.
• Before starting work, you should have a project plan showing the number of ventilation devices,
the location of the ventilation devices, the ventilation principle (cross ventilation, single room
ventilation, extract ventilation) and the associated controllers. The exact positioning of the
individual devices and control units must be checked at the installation site and, if necessary,
adapted to the local conditions with the involvement of the responsible planner or user. For
optimum functionality, it is recommended to install the unit at an appropriate place in the upper
wall area.
• WARNING:
For joint operation with open-flue and balanced-flue fireplaces, safety measures
must be taken to prevent a negative pressure from developing in the building. The responsible
chimney sweep and/or building planner decides which measures need to be carried out.
•
NOTICE:
The ventilation unit is not suitable for drying out buildings.
Do not put it into operation until the construction work has been completed.
•
NOTICE:
Contamination of components, e.g. by plaster residue, will damage the components!
Seal the ventilation unit/air outlets of the ventilation unit so they are dust-tight throughout the
construction work. Do not remove any thread locks present until final assembly.