IAR #DEFINE
POWER_SAVING: Accept µC low power mode
REMOTE_TI: use remote TI key matrix
USE_POINTING_LIB: use air motion lib
USE_POINTING_SENSOR: use raw sensor
USE_GAMING_AGL: use air gaming lib
USE_IMU3000: use IMU3000 gyroscope (I2C only)
USE_KXTF9: use KXTF9 accelerometer (I2C only)
USE_MPU9150: use MPU9150 accelerometer and gyroscope (I2C only)
USE_MAGNETO: use MPU9150 magnetometer for 3A3G3M (I2C only)
USE_FLIP_DETECTION: use flip detection
USE_TRIGGER_FOR_POINTING: use trigger for pointing only in the use case “Pointing Off”, gesture is disabled.
UPGRADE METHOD
WITH IAR
Dongle:
•
Plug the probe
•
Press Reset key on the probe. The LED should turn green.
•
Load the firmware with IAR
Remote:
•
Plug the probe
•
Press Reset key on the probe. The LED should turn green.
•
Load the firmware with IAR
Page
6
of
21
Summary of Contents for MoveaTV BLE REMOTE
Page 19: ...Page 19 of 21 ...
