43
7.6
Controlling the wheelchair using the remote
•
Switch on the remote (ON/OFF button). The displays on the remote will illuminate. The
wheelchair is ready to drive.
•
Set the drive level (“drive level“ button see
"Layout of the remote"
on page
37).
•
Speed stage 1 (slow) to 5 (fast) is shown on the drive level display.
Can the electronic system programming be adapted?
The electronic controller is programmed with standard values during manufacture. Your
Invacare® dealer can carry out programming tailored to fit your requirements.
WARNING: Any alteration to the drive programme can influence vehicle handling and the
tipping stability of the electric vehicle!
•
Alterations to the drive programme may only be carried out by trained Invacare® dealers!
•
Invacare® supplies all electric vehicles from the factory with a standard drive programme.
Invacare® can only assume a warranty for the safe vehicle handling of the electric vehicle –
in particular tipping stability - for this standard drive programme!
Will the wheelchair not drive after switching on?
Check the drive-away lock (see chapter
"Activating / deactivating the immobilizer "
on page
41
) and the status bar indicator (see chapter
"ON/OFF diode (status display)"
on page
40
.).
Summary of Contents for Typhoon II
Page 1: ...Invacare Typhoon II Electric wheelchair Operating manual Yes You Can...
Page 64: ...64 8 3 2 Flex and Contour Seats Set the angle by turning the hand wheel 1...
Page 76: ...76 Loosen the screw 1 using the Allen key Set the desired angle Re tighten the screw...
Page 150: ...150 Order No of this Manual 1521645 DOC Release Date 19 03 08 English...
