Invacare Topan, User Manual

Page: 92 / 107

92
NOTE
In case the old inner tube is to be repaired and used again, and it happens to get wet during
repair, then it is easier to re-fit it if you powder it lightly with talcum powder.
NOTE
Re-assembly is done in reverse order. Make sure that the wheel is put back on the same side it
was on, and that it runs in the same direction it did before it was removed.
•
Re-fit the rim halves back into the tyre.
•
Pump up the tyre a little.
•
Insert the cylinder head screws in the rim and tighten to 10 Nm. Make sure the inner tube
does not get pinched between the rims halves!
•
Check to make sure that the tyre is squarely in place on the rim.
•
Pump up the tyre to the recommended tyre pressure.
•
Check to make sure that the tyre is still squarely and snugly in place on the rim.
•
Screw the valve cap back on.
•
Refit the wheel.
•
Refit the Torx screw using threadlock and tighten to 30 Nm1