Invacare Storm 4 Series, Service Manual

Page: 89 / 102

Service
Removing Tilt Spindle
1. Remove upper pin retainer clip A .
2. Remove upper pin B and tip tilt spindle C forward.
3. Remove lower pin retainer clip F .
4. Remove lower pin D and tilt spindle. Take care of
spacers
E
.
5. Replace tilt spindle.
Fig. 6-115
Installing Tilt Spindle
1. Install parts in reverse order.
2. Test all functions.
6.12.4 Replacing Tilt Bracket
CAUTION!
Risk of strains from lifting heavy parts!
– Use proper lifting techniques.
We use different types of tilt carriers in our mobility devices. Due to this fact the carrier on your mobility device may look
different to the illustrations below. The following mounting instructions are not affected by this.
• 6 mm Allen key
Removing Tilt Bracket
1. Remove seat frame. See 6.12.5 Replacing Seat Frame,
page 90 .
2. Remove tilt spindle or tilt actuator. See 6.12.3 Replacing
Tilt Spindle, page 88 (manual tilt) or 6.12.2 Replacing
Tilt Actuator, page 88 (powered tilt).
3. Loosen and remove screw E , washer D and bushing C
on both sides of seat support
A
.
4. Replace tilt bracket
B
.
Fig. 6-116 Schematic diagram of a tilt bracket
Installing Tilt Bracket
1. Install parts in reverse order. Ensure that holes of tilt
sheet
H and seat frame are in line.
2. Test all functions.
1533060-N 89