Invacare® Storm⁴ Series
1.
Please take into account that the seat is very heavy. Be sure not to crush your fingers or other parts of the body. Use
proper lifting techniques.
2.
Loosen and remove two Allen screws (3) with a 6 mm Allen key.
3.
Tilt seat to the desired gradient.
4.
Place two parts of strut on top of each other.
5.
Refit Allen screws and tighten them.
6.
Check all mobility device functions.
4.5.2 Adjusting Seat Tilt on a Seat With Manual Tilt Module
CAUTION!
Risk of crushing
Seat and frame are very heavy and can fall down without warning if seat tilt adjustment assembly is screwed
apart too far. Risk of injury to hands and feet.
– Only change adjustments when nobody is seated in chair.
– Only change tilt adjustment to where distance between axles is a maximum of 300 mm.
•
19 mm wrench
•
Measuring tape
1.
Apply wrench to bolt (1) of tilt adjustment.
2.
Turn tilt adjustment till desired angle is attained or
distance between bolts is a maximum of 300 mm.
Fig. 4-8
16
1533060-N
Summary of Contents for Storm 4 Series
