Invacare Shark II/SPJ+, User Manual, Page: 18 / 20

18
1.11 Error Codes and Diagnostic Codes
FLASH
CODE
FAULT EFFECT Comments
1 User error or drive
motors overloaded Stops driving
• Ensure that the joystick is in the neutral
central position (simply release the
joystick) and switch on again.
•
Drive motors overloaded. Shut
electronics down and then switch on
again. If the driving power is still reduced,
wait a few minutes.
2 Battery error Stops driving •
Check battery and supply cable.
• Charge batteries. If you switch the
wheelchair off for a few minutes, the
batteries can often recharge to such an
extent that a short run is still possible.
However, you should only do this in an
emergency, as this causes the batteries
to discharge excessively.
•
Replace batteries
3 Fault on left-hand
motor (M2) Stops driving
• Check motor cable and connecting plugs.
•
Check motor.
4 Fault on right-hand
motor (M1) Stops driving •
Check motor cable and connecting plugs.
•
Check motor.
5 Error on left-hand
(M2) wheel lock Stops driving •
Check cable and connecting plugs.
•
Check brake.
6 Error on right-hand
(M1) wheel lock Stops driving •
Check cable and connecting plugs.
• Check brake.