Scorpius
Service Manual
1654773~A
29
❖
A lead-acid battery is heavy and does not need to be secured with screws. Place it directly into the pack
and make the connections.
Lithium battery relevant
specification.
Lithium battery warnings.
QR Code: Use such code to obtain
information related to the lithium
battery.
Lithium battery serial number barcode.
Battery Setting Instructions:
Please refer to Service Procedures SERVICE-01 Steering Shroud Repair steps, then:
1. Find the small battery type selection switch on the lower part of the top control board.
2. Move it to LI (left): Lithium battery, or PB (right): Lead-acid battery.
3. This switch resets the parameters to suit the type of battery. Make sure to push the switch completely to
the end (either left or right). If this is not done properly, system determination may fail.
❖
The lead-acid/ lithium battery
parameter setting can only be
done on the automatic version.
2.6.4
SERVICE-06-4 Charger Repair
1. Lithium battery standard 2A charger (see figure on the right)
Output connector. Input range 100~240 V
(The mains plug may vary depending on the sockets used in the
country or region.)
Input connector: four pins.
Description: The charging indicator shows Standby: red light/ Charging:
orange light/ Charged: green light.
•
After a change of battery type, be sure to change the steering head charger socket and the
battery pack charger socket. See
SERVICE-01-6 Steering Head Charger Socket
Repair and
SERVICE-06-1 Battery Pack - Charger
Socket Repair. Do not attempt to modify the charger
socket or charger cable connector. This can be very dangerous and have severe
consequences.
•
If the selection switch is not set for the correct type of battery after a change of type, the
scooter will run, but the battery level display on the panel will not show the correct state of the
battery.
•
Do not attempt to modify the charger socket or charger cable connector. This can be very
dangerous and have severe consequences.
