Scorpius
Service Manual
1654773~A
20
2.2.1
SERVICE-02-1 Main Cable Repair
Follow the
Repair steps and then:
1.
Please refer to
SERVICE-01-3 Starter VR Repair
and VR controller.
2. Insert the front end of the main cable into the hole on the top of the steering bar.
3. Remove the adjustment screw.
4. Disengage the central locking pin to separate the steering bar into upper and lower sections.
5. Remove the main cable from the upper section of the steering bar.
6. Remove the main cable from the lower section of the steering bar.
7. Take out the main cable and the complete steering bar.
❖
After the replacement of parts or re-installation, please follow the exact reverse sequence for reassembly.
•
Step 5. If it cannot be removed or replaced easily, use a rubber hammer to drive bar into
position.
•
After cutting (steps 2 and 3), when re-installing, use a new cable tie and place it in the
original position.
