Invacare SB 400, Service Manual

Page: 6 / 24

Invacare® SB® 400
3 Assembly
3.1 Receiving the bed
When you receive the bed, check the packaging. If the packaging
shows any signs of damage upon delivery, please contact the shipping
company. If the bed shows damages - do not use the bed.
WARNING!
Risk of personal injury or damage to property
–
After each assembly, check that all fittings are properly
tightened and that all parts have the correct function.
–
The electrical equipment of the bed must not
be dismantled or combined with other electrical
equipment.
CAUTION!
Risk of personal damage
There is a risk of entrapment or squeezing, while
assembling or disassembling of the bed.
– The assembly of the bed and mounting of accessories
must be done by qualified personnel.
IMPORTANT!
Risk of condensation
–
The bed should not be used until it has reached a
temperature of 10-40° C.
3.1.1 Main parts of bed
B
C
D
A
A
Backrest
B Seat section
C
Thigh section
D Leg section
3.1.2 Accessories / Components
For accessories, please see more information in the instructions
delivered with the accessory.
Important
–
Use only original accessories and spare parts. Spare
parts lists and extra user manuals can be ordered from
Invacare .
The tools necessary for mounting/dismounting the accessories of
the bed are:
•
Allen key
•
adjustable spanner
3.2 Mattress support
Bed parts (including mounted motors) can be heavy. Follow
the instructions carefully and, if possible, be two persons.
Follow special instructions for two.
All accessories (bed ends, side rails, lifting pole etc) have to
dismounted before disassambly of bed,
IMPORTANT!
Risk of injury while lifting heavy bed parts
– Be careful and pay attention to your body posture,
during assembly of bed.
IMPORTANT!
After assembly of the mattress support, check:
– that all plugs (motors and hand controls) are correctly
connected to the control unit according to the printed
symbols.
–
that both sections of the mattress support are
completely pushed together and the finger screws
tightened.
–
that bed ends are correctly attached and that the
mattress support is attached to the shear arms (snap
lock engaged).
3.2.1 Assembly of mattress support (2 persons) —
Recommended
IMPORTANT!
–
Two persons are needed to carry out these
instructions.
Person one = in the head end of the bed.
Person two = in the foot end of the bed.
1. Lock the brakes.
2. Insert the plug from the hi/lo motor in the control box and
connect the bed to the mains.
3.
Use the hand control to raise the bed until the plastic guides are
centred in the middle of the guideways.
4. Disconnect all motor plugs from the control box and disconnect
the bed from the mains.
5.
Pull out the red buttons L on each side of the mattress support
section and turn them anti-clockwise to open the snap locks E .
Pin out = open.
6 1581143-A