Invacare rea Focus, User Manual

Page: 15 / 48

Components
A
1. Remove the armrests and the seat cushion.
2. Loosen the two screws
A
.
3. Adjust the seat width.
4. Re-tighten the screws.
If the wheelchair is equipped with Flip-up armrests, the
following also needs to be done:
B
1. Loosen the screws
B
.
2. Re-tighten both screws
A
and the screws
B
5 mm allen key
4.9 Adjusting the seat
A
B
C
1. Loosen the screw
A
.
2. Adjust the seat front B to the desired position.
Only adjust the seat front within the marked area
C
.
Max adjustment 5 cm
3. Re-tighten the screws again.
4. Repeat the procedure on the opposite side if necessary.
The seat front
B
can also be removed completely if
necessary.
Screwdriver
4.10 Adjusting the legrests
4.10.1 Angle adjustable legrest
Angle adjustable legrests support the legs and reduces pressure. The
legrests must always be fitted with calf pads, foot plates and heel
straps. It is important to adjust the height and angle of the legrests to
obtain a good seating position.
Adjusting the legrest height
A
1. Loosen screw A with an allen key.
Tools: 5 mm allen key
2. Adjust the legrest to a suitable height and the screw is caught by
one of the recesses on the legrest tube.
3. Re-tighten the screw.
Angle adjustment
WARNING!
Risk of damage
Damage on the mechanism
– Do not place anything heavy, or let children sit on the
legrest. It may cause damage to the mechanism.
–
Do not put any pressure on the legrest while the angle
is being adjusted. The lever must be fully opened.
A
B
1. Pull the lever
A
with one hand while supporting the legrest with
your other hand.
2. When a suitable angle is obtained, let go of the lever and the
legrest will lock into one of seven preset positions
B
.
1431580-B 15