4 Options
4.1 Inlay cushion seat
A
B
1.
To obtain a flat seat, place the inlay cushion
A
on the
seat plate.
2.
Fit the inlay cushion at the back of the seat plate
B
.
4.2 Trunk support Swing away
Height adjustment:
A
B
1.
Loosen the screws
A
.
2.
Slide the trunk support holder
B
up or down to the
desired position.
3.
Re-tighten the screws.
The "swing-away" trunk support can be turned
sidewards in order to be out of the way when the
user is moving in to or out of the wheelchair.
CAUTION!
Risk of pinching
– The cover on the trunk support arm must
always be on when the chair is in use.
Angle adjustment:
A
B
1.
The angle can be adjusted by loosening the screws
B
and bolts
A
on the trunk support arm.
2.
Hold with the allen key and tighten with the fixed
spanner.
3.
Remember to re-tighten the screws and bolts when the
required position is achieved.
5 mm allen key / 13 mm fixed spanner.
Depth adjustment:
C
D
1.
Open the zip on the cover
C
.
2.
Loosen the screws
D
.
3.
Adjust the trunk support to the desired depth.
4.
Re-tighten the screws
C
.
5.
Close the zip on the cover.
Screwdriver
CAUTION!
Risk of pinching
– Be careful not to pinch your fingers between the
trunk support and the wheel when propelling
the chair..
4.3 Trunk support fixed arm
Height adjustment:
A
1.
Loosen the screw
A
.
2.
Adjust the attachment upwards or downwards to the
desired height.
3.
Re-tighten the screw
A
.
1431580-C
17
Summary of Contents for Rea Focus 150
Page 54: ...Notes...
Page 55: ...Notes...
