Adjusting the mobility device to the user's seating posture
6.9
Cushion Covers
6.9.1
Removing/Installing the Seat Cushion Cover
1.
Pulling up to release the hook and loop strips
A
, remove the
seat cushion
B
to the seat pan
C
.
2.
Open the fold along the bottom of the seat cushion.
3.
Remove the seat cushion cover from the seat cushion.
4.
Reverse STEPS 1-3 to reinstall the seat cushion cover.
6.9.2
Removing/Installing the Back Cushion Cover
1.
Pulling the back cushion
D
towards the front of the personal
transporter to release the hook and loop strips
E
, remove the
back cushion from the back pan
F
.
2.
Open the fold along the bottom of the back cushion.
3.
Remove the back cushion cover from the back cushion
4.
Reverse STEPS 1-4 to reinstall the back cushion cover.
6.9.3
Cleaning the Cushion Covers
CAUTION!
–
Machine wash cold. Gentle cycle. Mild detergent. No
fabric softeners or bleach.
–
DO NOT machine dry. Air dry ONLY out of sun.
6.10
Adjusting Forks
This procedure must be performed by a qualified technician.
This procedure applies to both Forks.
1.
Remove the head tube cover
A
from the caster head tube
B
.
2.
To properly tighten caster journal system and guard against
flutter, perform the following check:
a.
Tip the personal transporter forward, toward the floor.
b.
Pivot both forks
C
and casters to top of their arc
simultaneously.
c.
Let casters drop to bottom of arc (wheels should swing once
to one-side, then immediately rest in a straight downward
position).
d.
Adjust locknuts
D
according to freedom of caster swing.
1580058-B
35
