8 FRONT RIGGINGS
60
Adjusting Calfpad Depth
1.
Remove the mounting screw (A), washer (B), and locknut (C) that
secure the calfpad (D) to the calfpad bracket (E).
2.
Secure the calfpad to one of four depth adjustment holes (F) using
the mounting screw, washer and locknut. Tighten securely.
3.
If necessary, repeat STEPS 1-3 to adjust remaining calfpad assembly.
FIGURE
6
8.5 Replacing Mounting Pin on 80° and 90° Front
Rigging
1.
Remove the front rigging (A) from wheelchair (B).Refer to
Installing/Removing Front Riggings on page 43.
2.
Remove mounting screw (C) that secures the mounting pin (D) to
the front rigging (A).
3.
Remove mounting pin (D) from front rigging (A).
4.
Install new mounting pin (D) into front rigging (A).
5.
Secure new mounting pin (D) to front rigging (A) with mounting
screw (C). Securely tighten.
6.
Install front rigging (A) onto wheelchair (B). Refer to
Installing/Removing Front Riggings on page 43.
FIGURE
Replacing Mounting Pin on 80° and 90° Front Rigging
Depth adjustment is only available on MyOn and
MyOn Active.
A,B,C
D
E
F
A
B
C
D
