Invacare® Modulite
Installing backrest unit
1.
Install parts in reverse order.
2.
To conclude, you should always carry out a trial run to test the
vehicle functions.
4.4
Replacing posture belts
4.4.1
Installation on backrest mounting bracket
(backrest frame)
Tools:
•
13 mm socket spanner
•
5 mm Allen key
•
Posture belts are attached via drill hole (1) on the top right.
4.4.2
Installation on backrest mounting bracket
(telescopic seat frame)
Tools:
•
5 mm Allen key
1.
Loosen screw
A
with a 5 mm Allen key.
2.
Remove screw
A
, corresponding washer
B
, seat belt, stopper
C
and belt winder
D
from backrest mounting bracket
E
.
3.
Replace posture belt.
4.
Install parts in reverse order.
4.4.3
Installation on seat frame profile (telescopic
seat frame)
Tools:
•
5 mm Allen key
1.
Loosen screw
A
with a 5 mm Allen key.
2.
Remove screw
A
, washers
B
, seat belt, stopper
C
, sliding
bushing
D
and T-nut
E
from seat frame profile
F
.
3.
Replace posture belt.
4.
Install parts in reverse order.
4.4.4
Replacing H-belt (telescopic seat frame)
Note:
•
13 mm socket wrench
•
5 mm Allen key
Removing H-belt
1.
Remove protective cap
B
.
2.
Loosen and remove screw
F
, associated washers
E
and nuts
D
(in front of the/behind the gripper clamp
C
) with a 5 mm Allen
key and a 13 mm socket wrench.
3.
Loosen and remove screw
J
, associated washer
I
, stopper
H
, belt winder
G
in the lower part of the H-belt
A
with a 5
mm Allen key.
A belt winder is installed, so that the belt bracket can move
freely.
4.
Replace H-belt
A
.
Installing H-belt
1.
Install parts in reverse order.
4.4.5
Replacing H-belt (backrest frame)
Note:
•
13 mm socket wrench
•
5 mm Allen key
12
1604311-A
Summary of Contents for Modulite Bora XTR Series
Page 26: ...Notes...
Page 27: ...Notes...
