Part No. 1114822
33
Tilt/Recline Seating Systems®
Adjusting the Footplate Depth (FIGURE 9).
1. Remove the two (2) flat head screws
and the two (2) barrel nuts that secure
the footplate to the footplate clamp.
2. Reposition the footplate on the
footplate clamp.
3. Align the depth holes on the footplate
to the mounting holes on the footplate
clamp.
4. Insert the (2) barrel nuts through the
bottom of the footplate clamp.
5. Install the two (2) flat head screws through
the footplate and footplate clamp.
6. Securely tighten with two (2) barrel nuts.
7. Repeat STEPS 1-6 for opposite footplate
if necessary.
Adjusting the Footplate Angle
(FIGURES 10).
1. Loosen, but do not remove the two (2)
flat head screws and the two (2) barrel
nuts that secure the footplate to the
footplate clamp. Refer to DETAIL A in
FIGURE 10.
2. Rotate the footplate clamp on the pivot
hinge until the desired angle is achieved.
Refer to DETAIL B in FIGURE 10.
3. Securely tighten footplate to footplate
clamp and hinge pivot with the two (2)
flat head screws and barrel nuts.
4. Repeat STEPS 1-3 for opposite side if
necessary.
5. For additional angle adjustment, perform
the following (FIGURE 10):
A. Loosen the set screw.
B. Rotate footplate up or down to
desired position.
C. Retighten set screw.
SECTION 8
RIGGINGS
Barrel Nuts
Footplate
Clamp
Depth
Adjustment
Holes
FIGURE 9- ADJUSTING THE
FOOTPLATE DEPTH
Flush Head
Screws
Footplate
Mounting Holes
Set Screw
Direction
of Rotation
Footplate
Clamp
Pivot
Hinge
Footplate
Barrel Nuts
Flush Head Screws
Footplate
Footplate
Clamp
FIGURE 10 - ADJUSTING THE
FOOTPLATE ANGLE
DETAIL A
DETAIL B
RIGGINGS
