Invacare® LiNX
6 Troubleshooting
6.1 General information on troubleshooting
The following information is intended to support you
recognize and rectify faults on the remote.
In case you require assistance, contact your authorized
Invacare provider.
6.2 Fault indication
When a fault occurs, a flash code is displayed on both the
primary remote module and the secondary remote module.
A flash code, which is displayed on the status indicator, is
a number of flashes separated by a 1.6 second gap; the
number of flashes depends on the fault. For example, one
flash represents flash code one; two flashes represents flash
code two, and so on.
Faults that affect the safety of the mobility device
cause the mobility device to stop, while less critical
ones are indicated but allow the mobility device to
continue driving. Some faults automatically clear
when the fault condition is removed (non-latched)
while others are latched and must be cleared by
turning the controller off, waiting five seconds, then
turning the system on again.
Faults are categorized according to their source — that is,
there are local faults (those that relate to the secondary
remote module), and there are system faults (those that
relate to one or more system modules). Local faults take
priority with the secondary remote module and so local
faults are displayed on the secondary remote module
instead of system faults
if
both local and system faults occur
at the same time.
When there is a local fault, the power button flashes red.
All other indicators are switched off. It is possible that the
rest of the system might not indicate a fault. All local faults
(faults with the secondary remote module) are displayed as:
Flash Code 1: Remote Fault
When there is a system fault, the power button flashes
red. All other LEDs continue to operate according to their
role. The rest of the system indicates the same fault or a
related flash code. System faults are displayed according to
the flash codes described in
6.2.1 Fault codes and diagnosis
codes, page 24
.
Contact your Invacare provider.
6.2.1 Fault codes and diagnosis codes
If there is a fault with the system when it is powered up, the status indicator flashes red. The number of flashes indicates the
type of fault.
24
1608055-C
Summary of Contents for LiNX DLX-ACU200
Page 28: ...Notes ...
Page 29: ...Notes ...
Page 30: ...Notes ...
Page 31: ...www invacarelinx com ...
