SECTION 14—BACK
Part No 1125031
67
SECTION 14—BACK
WARNING
After any adjustments, repair or service and before use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustments or service, always turn the wheel-
chair power off, otherwise injury or damage may result.
Removing/Installing/Adjusting the Curved Back Pan
NOTE: For this procedure, refer to FIGURE 14.1 on page 69.
NOTE: The following tools and items are required to perform this procedure:
• 7/16-inch Socket with Ratchet
• 9/64-inch Allen Wrench
Removing the Curved Back Pan
1. Remove back cushion.
2. Remove the four locknuts that secure the curved back pan to the back canes.
3. Remove the curved back pan from the upper mounting brackets.
Installing the Curved Back Pan
1. If the fastening strips and upper curved back pan mounting screws have been
removed from the curved back pan, and/or the upper mounting brackets have been
removed from the back canes, perform the following steps:
A. Install two curved back pan mounting screws through the front of the curved back
pan.
B. Position one upper mounting bracket onto the back cane.
C. Install the small mounting screw to secure the upper mounting bracket to the back
cane.
D. Repeat STEPS B and C for the remaining back cane.
2. Install the two spacers onto the upper curved back pan mounting screws.
NOTE: The spacer channel should face the rear of the wheelchair.
3. Insert the two upper curved back pan mounting screws through the upper mounting
brackets.
4. Rotate the spacers so the upper mounting brackets fit flush into the spacer channels.
NOTE: The spacer channels should be oriented toward the inside of the wheelchair.
