Disengaging the drive
1.
Switch off the scooter (keyswitch).
2.
Press the unlocking knob
A
on the disengaging lever.
3.
Push the disengaging lever forwards.
The drive is disengaged. The scooter can be pushed by hand now.
Engaging the drive
1.
Pull the lever to the rear.
The drive is engaged.
6.8
Driving the scooter
WARNING!
Risk of injury from the unintended rolling of the
vehicle
When stopping the vehicle, the drive lever needs to
return entirely to the middle position to activate the
electromagnetic brakes. If there is any obstruction
stopping the lever from returning to the middle position,
the electromagnetic brakes cannot be activated. This can
lead to the vehicle rolling unintentionally.
–
Ensure that the drive lever is in the middle position, if
the vehicle is to remain stationary.
1.
Switch the power supply on (keyswitch).
The operating console display illuminates. The scooter is ready
to drive.
If the scooter is not ready to drive after switching on, check
the status display (refer to 3.3 Operating console (LCD
version), page 19 and 11.1 Diagnosis and fault repair, page
52).
2.
Set the required speed with the speed controller.
3.
Pull the right-hand drive lever carefully to travel forwards.
4.
Pull the left-hand drive lever carefully to travel in reverse.
The control system is programmed with standard values
in the works. Your Invacare provider can carry out
programming tailored to fit your requirements.
WARNING!
Any changes to the drive program can affect the
driving characteristics and the tipping stability
of the vehicle.
–
Changes to the drive program may only be carried out
by trained Invacare providers.
–
Invacare supplies all mobility products with a standard
drive program ex-works. Invacare can only give a
warranty for safe vehicle driving behavior - especially
the tipping stability - for this standard drive program.
To brake quickly, simply let go of the drive lever. It will then
automatically return to the middle position. The scooter
will brake.
To brake in an emergency, follow the above and pull the
handbrake lever until the scooter comes to a halt.
1603455-A
35
Summary of Contents for Comet Series ALPINE Plus
Page 31: ...Accessories Change the front side shroud Change the rear side shroud 1603455 A 31...
Page 61: ...Notes...
Page 62: ...Notes...
Page 63: ...Notes...
