Invacare Comet Series ALPINE Plus, User Manual

Page: 52 / 64

Invacare® Comet Series
11 Troubleshooting
11.1 Diagnosis and fault repair
The electronic system offers diagnostic information to support the
technician during the recognition and rectification of faults on the
scooter.
The electronic system reacts differently depending on the seriousness
of the fault and its effect on user safety. It can, for example:
•
Display the error code as a warning and allow both driving and
normal operation to continue.
•
Display the error code, stop the scooter and prevent further
travel until the electronic system has been switched off and
switched on again.
•
Display the error code, stop the scooter and not permit further
travel until the fault has been rectified.
You can find detailed descriptions of individual error codes, including
possible causes and fault repair, in 11.1.2 Error codes and diagnostic
codes, page 53.
11.1.1 Error diagnosis
If the scooter shows a failure, use the following guide to locate the
fault.
Before making any diagnosis, ensure that the scooter has
been switched on at the keyswitch.
If the status display/LCD display is OFF:
•
Check whether the keyswitch is SWITCHED ON.
•
Check whether all cables are correctly connected.
LED console
If there is a fault, the status display (1) flashes several times, pauses,
then flashes again. The type of fault is displayed by the number of
flashes which are also known as the "flash code". Count the number
of flashes and proceed to 11.1.2 Error codes and diagnostic codes,
page 53.
LCD console
If there is a fault, the fault indication symbol A , the number B and
the name of the fault
C
are shown in the LCD display. Refer to
11.1.2 Error codes and diagnostic codes, page 53.
52 1603455-A