Invacare Celt Plus, Maintenance And Spares Parts Manual

Page: 27 / 78

11/03 Page 2.19
MAINTENANCE
2.3.3 Configuring The Chair For 20 in, 22 in or 24 in Wheel And Brake
Assembly
General
1 The CELT can be configured to accept the following set-up:
1.1 20 in, 22 in or 24 in Quick Release wheel configured for self-propelling.
☞
Note: For parts identification refer to Chapter 3.
Configuring
2 To configure the chair, the above information is required (check the order).
3 The following procedure is for guidance only:
3.1 Select the relevant sized wheel.
3.2 Fit the wheel into the correct locking hole on the chassis frame.
☞
Note: All locations are given when looking from the swing/detachable footrest assembly end.
4 Fit the brake assembly (1) into place on the chassis frame under the seat canvas.
5 Using the adjusting bar correctly position the stop bar on the brake to a suitable position so that when the
brake is operated the wheel locks.
6 Repeat paragraphs (3 to 5) for the other side
☞
Note: 22 in wheel in R.W.S.B. position is bolt on not quick release.