1.
Remove the plastic cover cap from the adjustment
screw (1).
2.
Loosen the screw, using the open-ended spanner 13
mm.
3.
Set the legrest to the desired length. Take care not to
rotate the lower part of the legrest in its support tube.
4.
Re-tighten the screws.
5.
Re-position the plastic cover cap.
5.22.3 Adjusting the angle of the legrest — Angle
adjustable legrest
Tools:
•
1 x open-ended spanner 13 mm
•
1 x open-ended spanner 10 mm
•
1 x Allen key 4 mm
1.
Loosen the fixation screws (1) of the pivotal points of
the angel adjustment, using the open-ended spanner 10
mm and the Allen key 4 mm.
2.
Loosen the clamping screw (2) of the angle adjustment,
using the open-ended spanner 13 mm.
On the underside of the legrest hanger there is a slit
A
in the outer tube, which allows visual inspection.
When adjusting the angle, the inner tube
D
should
only ever be pulled out so far that its end is flush
with the edge
B
of the clamp
C
.
1528224-Y
79
Summary of Contents for Bora Series
Page 126: ...Notes...
Page 127: ...Notes...
