1.
Release wing screw (2).
2.
Remove the armrest from the mounting.
3.
Remove the screw (1) using the Phillips screwdriver.
4.
Set the new armrest height by selecting a higher or
lower screw hole.
5.
Retighten the screw.
6.
Introduce the armrest into the mounting again. Tighten
the wing screw.
7.
Repeat the process for the other side if necessary.
5.3.2 Adjusting the width of the armrests
WARNING!
Serious injury hazard if one of the armrests
falls out of its bracket because they have
been adjusted to a width which exceeds the
permissible value
– The armrest width adjustment for the Firm seat
unit is limited on both sides by a spring-loaded
pin. This limiting pin may only pressed in
to remove the armrest completely (e.g. for
getting in and out) and never to extend the
width adjustment.
1.
Loosen clamping lever (1).
2.
Adjust armrest to required position.
3.
Retighten the clamping lever.
4.
Repeat this procedure for the second armrest.
5.4 Adjustment possibilities for the Flex 2 seat
unit
5.4.1 Adjusting width of the Flex 2 standard armrest
•
8 mm Allen key
1528224-Y
35
Summary of Contents for Bora Series
Page 126: ...Notes...
Page 127: ...Notes...
